Powerdyne King Pin for Reactor Plates(Single)

<p>Roll Line Mounting Hardware for Roller Skates. Roll Line bolts are diameter 3.5mm, witch is a little bit thinner than the US standard. This hardware is matching with the Roll line plates holes. Set of 12 Bolts(4 long+8 short) with nuts and washers.</p>

<p>5/8" Stopper Washers Set. For locking your 5/8" adjustable stopper to your skate plate. Can be use one Powerdyne Thrust/Triton/Dynapro plates, and Sure Grip plates. Not compatible with plates using bell stopppers or the ones that required Allen key to tighten stoppers. <strong>Set of 2 washers(For both plates)</strong></p>

<p>Bont Toe Stop Screws for Tracer roller skate plates. Set of 2 screws</p>

<p>This Sure-Grip toe stop screws will allow you to keep your stoppers in place on most Sure Grip plates. Only compatible with the following plates: Avanti, Avenger, Competitor, Cenury, Classic, Cyclone, Magnum, Invader. <strong>Set of two srews</strong></p>

<p>Roller Quad Toestop bolts(Set). To be use with bell type stoppers. Diameter 5/16". <strong>Set of 2 bolts</strong></p>

<p>This Pilot toe stop screws will allow you to keep your stoppers in place on Pilot Falcon plates. <strong>Set of two srews</strong></p>

<p>Independent Genuine Parts Axle Rethreaders feature a pilot shaft that makes it super easy to properly place on and rethread your trucks axles. Package comes with 1 pilot shaft rethreader, 4 fresh axle nuts, and a Genuine Parts sticker.</p>

<p>5/8" Stopper Nuts &amp; Washers Set. For locking your 5/8" adjustable stopper to your skate plate. Can be use one Powerdyne Thrust/Triton/Dynapro plates, and Sure Grip plates. Not compatible with plates using bell stopppers or the ones that required Allen key to tighten stoppers. <strong>Set of 2 nuts and 2 washers(For both plates)</strong></p>